10
The frequency used by the fan remote control can be changed
if interferences are experienced in the home.
NOTE: This information only pertains to the Coffee Table
(MBCT500) unit. Unplug the power lead before proceeding.
Remote Control Receiver
The remote control receiver has four small switches on the
side, as seen in the photo below. Change the switch setting to
something different than current setting. Remember this
switch setting as it will need to be replicated on the fan
controller.
To access the remote control receiver:
1)
On the underside of the Coffee Table in the back right
corner, there will be 2x M6 hex screws.
Loosen
these
using an M6 hex key.
2)
On the shelf above these screws there will be a cover
that needs to be pulled outwards towards the rear of
the heater to remove.
3)
You will now see the receiver box. Remove the 2x M6
hex screws on top with an M6 hex key.
4)
You will now have access to the receiver.
5)
Repeat steps 1 to 5 in reverse to re-install.
Fan Controller
Remove the battery cover and batteries. With a small
screwdriver or equivalent, change the switch setting to be the
same as that on the remote control receiver.
Replace the batteries and cover, plug in the power lead and
test the fan with the different frequency setting. If
interferences are still experienced, repeat the steps with
another switch setting configuration.
Fire Bricks
6 @ 220 x 175 x 25mm
1 @ 220 x 140 x 25mm
3 @ 220 x 85 x 25mm
Baffle Plate
480 x 6mm
Door Latch Bushing
10mm OD x 20mm aluminium
Door Seal
1600 x 14mm round
Glass Seal
1900 x 19 x 3mm flat adhesive backed
Brick Retainer
485 x 290mm
Door Glass
620 x 436 x 5mm Robax
Fan Remote Control
3 speed
Fan Remote Receiver
3 speed
Fan
3 speed
9. REPLACEMENT SPARE PARTS LIST
8. CHANGE FAN CONTROLLER FREQUENCY
