VIBRATION TRANSMITTER-VT7S12E
Ref No: mVTD/om/201
Issue No: 02
User’s Manual
- 8 -
4. FRONT PANEL DESCRIPTION
Figure 1 Front Panel Description
Name of Part
Function
Process Value
Display
(DATA window)
Displays Process Value.
Display Parameter Name When You Set Parameter.
Displays Error Message When An Error Occurs.
Channel No. Display
(CHANNEL window)
Displays Channel Number in run mode. Also it will display relay number (01
– 04)
in set mode (i.e.R.1,R.2,R.3,R.4)
It will also display Group no(GP 1,GP 2/GP 1,GP 2,GP 3,GP 4) in set mode
Relay Status LED
(RL1, RL2, RL3,
& RL4)
OR
Open Sensor Indicator LED
When Respective Relay LED Lits (In Red).
OR
When Channel is OPEN (Channel no. is corresponding to Relay no.)
Auto/Manual status LED
(A/M)
If LED is on, it indicates Manual mode and if LED is off Auto Mode.
Communication Status LEDs
(R,T)
When Communication on, two LEDs (In Red) blink.
Input Type Status LEDs
(A, V, D, T)
Depending upon the channel Input type LED is on.
Table 4 Front Panel Description
5. KEY FUNCTION DESCRIPTION
MENU/ENTER KEY:
It is used to enter in the sub menu (various levels) and save the parameters to nonvolatile memory, when user setting a proper data
by Increment and shift key for parameter configuration.
ESCAPE KEY / AUTO-MANUAL KEY:
It is used to come out from any sub menu (various levels) to the run mode. It is used for come out of the manual mode to auto mode
too.
INCREMENT KEY:
It is used to increment the parameter for selection. Value of parameter can be incremented by pressing this key. When first time
increment key is pressed, DP (decimal point) in PV display blink, so user can modify the value with increment key. It is used to
increment the value in particular digit. Value can be incremented from 0-
9 and from „9‟ again it rollovers to „0‟. The function
Auto/Manual is integrated with this key. This key is used to enter into manual mode while the unit is in run mode.
SHIFT KEY/DECREMENT KEY:
It is used to Shift the digit to set the parameter as describe in increment key when DP (decimal point) started to blink. Menu key is
used to go forward to show next parameter and Shift key is used to go backward to show previous parameter. It is also used to
acknowledge the trip relay.
