Ref No.: mTTC/om/101
Issue No.: 04
2 |
P a g e
TT7S00-HR
S
AFETY AND WARNING
As all transmitters with potentiometer adjustments,
TT7S00-HR transmitter must not be exposed to heavy
shocks or vibration which may cause the transmitter to
get out of calibration.
To avoid Electrostatic Discharge (ESD) to the
transmitter, which may cause permanent damage,
always ground yourself by touching some ground
equipment before configuring the transmitter.
Always use the cover when the transmitter is not in the
configuration phase. The cover prevents the transmitter
from getting dirt on the soldering pads as well as getting
ESD by accidental touch of the soldering pads.
C
ONFIGURATION AND CONNECTION
Configuration of the transmitter should always
be carried out by qualified person only.
To ensure that the device can be operated safely
and all functions can be used, check all
cables correctly connected according to
connection diagram.
1. Zero selection
2. Span selection
3. Burn out detection selection
4. Connection
For Input signal:
Connect terminal no. 1,2 and 3
as per below connection details.
For Output signal:
Connect terminal no. 4 and 5
as per below connection details.
I
NSTALLATION
On DIN Rail
– 35 mm DIN
Mounting:
The unit can be snapped onto all DIN rails
according to EN60715. The device must be
mounted horizontally
(Input terminal blocks facing upper wards)
The housing is mounted on the DIN rail by swiveling
it Into place.
Removal:
Release the snap-on catch using a screwdriver and
then detach the module from the
bottom edge
of
the DIN Rail.
Head Mounting:
Mounting:
The Unit can be mount with 2 screws given with the
sensor head as shown in figure with screw driver.
