a b
c
d
e
f
2
3
1
4
5
6
7
8
9
SAFETY
NOTE !
WATER PRESSURE
This mixer is suitable for use at all supply pressures. However for
optimum use both the hot and cold supplies should be reasonably
balanced. If the fitting is installed at low pressure (tank fed), then the
minimum height from the highest installed position of the showerhead
to the underside of the cold tank should be 1.0 metre to ensure
adequate shower performance.
This mixer should be installed in compliance with Water Regulations.
Where the supplies are unbalanced, i.e. hot water from cylinder
tank/cold from the mains, approved check valves must be fitted in the
supply pipes. For further details contact your Local Water Authority.
INSTALLATION DIAGRAM
Please Note:
In the unlikely event you find a part missing please
contact our Customer Service Help line on 0844 701 6273 for
immediate dispatch of part.
CONTENTS
1. Mixer Body
(x1)
6. Hands et Holder
(x1)
2. Rubber Washer
(x2)
7. Fixing Screw
(x1)
3. Backnut
(x2)
8. Wall Bracket
(x1)
4. Hose
(x1)
9. Handset
(x1)
5. Small Washer
(x2)
INSTALLATION
1.
Identify all components and check for completeness, particularly
before arranging f itting.
2.
Fit the mixer body (1) to the bath and secure using the rubber
washers (2) and backnuts (3) below the bath. Connect the hot
and cold water supplies.
3.
Fit the hose (4) to the mixer (1) and the handset (9) using the
small sealing washers (5). To adjust hose outlet position; loosen
screw (f) then rotate hose outlet to desired position. Secure in
place with grub screw (f).
Prior to drilling into walls, check there are no
hidden electrical wires, cables or water supply
pipes with the aid of an electronic detector. If you
use power tools do not forget to:
•
Wear eye protection
•
Unplug equipment after use
4.
Fix wall bracket (8) to wall using the screw (7) and wall plug
provided, ensuring that the handset will reach it. Attach bracket
handset holder (6).
5.
Fully open both valves letting them run for a few minutes, check
all joints and connections for leaks.
6.
Operate the mixer in both bath and shower mode. To switch
from bath to shower mode, pull the diverter knob (e) up. After
use the mixer automatically reverts to the bath-filling mode.
MAINTENANCE
If the fitting begins to drip:
1.
Turn off the water supply.
2.
Prise out cap (a), loosen grub screw (b) and lift off handle (c).
3.
Remove valve (d). Clean seating, seal and ceramic disc.
4.
Replace valve and head and turn on the w ater supply.
5.
Contact our helpline if problem persists.
For latest prices and delivery to your door visit MyTub Ltd 0845 303 8383 www.mytub.co.uk
