Maschio WEEKEND WARRIOR 6042, Использование и обслуживание, Страница: 27 / 46

cod. F07011720
EN - 27
NOTE: Make sure to replace tines on ONE spindle at a time to keep spiral tine pattern.
5. Remove left-hand tine and right-hand tine (B).
6. Install new tines and fasten with bolts, lock washers, and nuts (removed above).
NOTE: Two bolts go in for each tine. Refer to sketch on Page 26.
7. Tighten bolts.
CAUTION: The heads of the bolts fi xing the tiller tines in place must be on the side of
the tiller tines themselves, while the nut with relative washer must be on the fl ange side
(B). Tighten bolts to 127 Nm (94 lb-ft).
TROUBLESHOOTING
Using troubleshooting chart
If you are experiencing a problem that is not listed in this chart, see your Maschio dealer for service.
When you have checked all the possible causes listed and you are still experiencing the problem, see your
Maschio dealer.
IF CHECK
EXCESSIVE TINE WEAR
Replace loose or bent tine.
Replace tine when worn to a point.
TILLER BUMPING ON GROUND
Obstacles entangled in tines.
Tines incorrectly mounted with no tine spiral effect.
Tines fi tted with blunt edge leading.
Broken tines.
INSUFFICIENT DEPTH OBTAINED
Adjust depth control skids.
Insuffi cient power - use lower tractor speed.
Gear cover on hard soil - further passes required.
Tines rolling over ground - use lower tractor speed.
Adjust depth control on tractor.
TILLED SOIL TOO FINE
Raise leveling board.
Use a faster tractor ground speed.
TILLED SOIL TOO COARSE
Lower leveling board.
Use lower tractor speed.
Wait until soil is drier.
TINES BALLING UP WITH SOIL
Raise leveling board.
Decrease tractor speed.
Ground too sticky for working.
CUTTING TOO DEEP ON ONE SIDE
Tiller not level:
• Level tiller.
• Adjust depth control skid.
NOT OVERLAPPING
Drive closer to last run.
Start in center and go around clockwise (tilled soil to the right of the operator.)