Masalta MR70E, Инструкция по эксплуатации

Страница: 5 / 12

4
NEVER cut off the power supply before turning engine starter switch to OFF when work
was done.
ALWAYS check power voltage before launching the machine, for a wrong power voltage
will cause critically damage to the motor.
ALWAYS check the connecting spares and ensure no loosing or cracked parts were
used. Always keep power cables in good state and have a reliable connection to the
earth.
ALWAYS keep the handle dry, clean, and oil or grease-free before launching.
ALWAYS make the operator have a clear sight in the work area.
ALWAYS operate the machine with two hands, and put one hand close to the engine
starter switch in case of an emergency.
ALWAYS check if the motor rotates the same direction marked on the label when it was
powered on. If not, change the phase line.
ALWAYS check the insulated rubber spares. If any damage or loose was found, replace
or fasten it.
NEVER make heavy pressure on the handle in a normal situation, it affects the jumping
height. While a moderate press would accelerate machine’s forwarding speed when it
works on soft stuffing or climbs a slope.
ALWAYS keep the machine in a dry and children-out-reach place after performance.
•
Electrical Equipment Operating Safety
DANGER
1. Operating safety rules have to be followed when the electric motor is working. Otherwise, it will
cause serious injury or death.
2. Make sure the employed extension cable fulfills rat
ed power currency requests and doesn’t have
any worn on surface.
3. Do not touch the ground, water pipe, metal railing, water tank, or any tube system directly with
your body during the operation.
4. Do not operate electrical rammer in rainy or snowy day; always keep the motor and wires in the
starter box dry.
5. Do not operate the machine in moisture circumstance.
6. The extension cable must be outdoors certificated when it is used outside.
7. The extension cable has to be equipped with special-purpose ground socket matc
hing machine’s
plug.
8. Always protect the cable against heat sources, oil, and sharp blade. Check if any worn on the
surface before every launching, if any, repair it or replace it immediately.
9. Make a periodic inspection of the cable. If any damage, replace it.