Marzhauser Sensotech PROFILER ST, Руководство по эксплуатации

Страница: 134 / 196

134
Operation Operating Manual
EN
Here you can learn how to enable the position correction after
restarting the PROFILER ST:
»
Chapter 6.5.3 Enabling the Position Correction, page 135
X
Modifying position correction values
1 Navigate through the saved segments with and .
2 To modify a target value, tap on the Target Pos. input field.
3 Enter the value of the measuring point approached on the
measurement standard via the entry bar.
4 Confirm your entry with .
5 To modify an actual value, adopt the currently measured
position value in the
Act. Pos. input field with .
Note: If you would like to enter or modify the actual value
manually, tap on the Act. Pos . input field. Enter or modify
the actual value via the entry bar. Confirm your entry
with .
6
Save the entered target and actual values for the segment
with
.
The new position correction values are now saved.
X
Deleting position correction values
1
To delete all segments which are saved for an axis along
with the associated target and actual values, navigate with
to segment 0 .
2 Delete all segments which were saved for the respective axis
with
.
3
Confirm the query Delete all position correction data of
axis? with .
All segments which were saved for the respective axis, along
with their associated target and actual values, are now deleted.