Marzhauser Sensotech PROFILER ST, Руководство по эксплуатации

Страница: 128 / 196

128
Operation Operating Manual
EN
6.3 Performing Measurements
NOTICE
Possible malfunction from incomplete commissioning!
Before you can take measurements with the PROFILER ST, you
must have fully commissioned the PROFILER ST.
»
Chapter 5 Commissioning, page 113
X
Performing measurements
1 If the position correction is configured for your measuring
setup, enable the position correction.
»
Chapter 6.5 Using the Position Correction, page 130
2 Position the sample/workpiece at the position from which
you want to perform the measurement.
3
Zero the position values with , or .
Note:
With a connected foot switch (optional accessory),
you can also zero the position values by pressing the left
pedal.
4 Approach the desired measuring point.
Now you can read the current position values from the position
display.