Marzhauser Sensotech PROFILER ST, Руководство по эксплуатации

Страница: 127 / 196

127
Operation PROFILER ST
EN
6.2.3 Status Display Position Correction
If position correction was enabled in the Encoder menu, the
display field appears to the left of the respective position
display (
X , Y , Z ).
Red, flashing Machine zero was not yet set or
approached.
The position correction is not active.
Green, constant Machine zero was set/approached.
The position correction is active.
Note: For absolute measuring systems,
the machine zero is detected directly
after switching on the PROFILER ST.
Therefore, the position correction is ac-
tive immediately after switching on the
PROFILER ST.
You can select the function for setting the machine zero in the
Origin menu.
»
Chapter 6.7.3 Origin, page 140
6.2.4 Status Display Reference Signal
If reference signal evaluation was enabled in the Encoder
menu, the display field appears to the left of the respective
position display ( X , Y , Z ).
White
The reference signal evaluation is enabled.
Green
A reference mark was approached.