＿
6
＿
Assembly
Assembling Engine and Shaft Assembly
Attach the clutch drum housing to the engine using the four
screws supplied with the unit.
Engine
Clutch Drum Housing
Shaft Assembly
Screw
（
4
）
Connecting Throttle Cable and Stop Switch Wires
1. Insert the throttle cable through the carburetor bracket, then
screw a cable adjuster sleeve into the carburetor bracket fully.
2. Position the slotted fitting on the carburetor so the recessed hole
for the cable lug is away from the cable adjuster sleeve.
3. Rotate the carburetor throttle cam and slip the throttle cable
through the slot in the slotted fitting, making sure the cable lug
drops into the recessed hole.
4. Operate the throttle trigger a few times to make sure that it works
correctly.
5. Adjust the cable adjuster sleeve so the stop on the carburetor
throttle cam just contacts the throttle stop and the cable position
keep 1-2mm play between cable lug and slotted fittings when the
throttle trigger is fully depressed.
6. When the throttle cable is adjusted correctly, tighten the lock-nut.
7. Plug the stop switch wires into the matching connectors from the
engine. Note that wire polarity is not important.
Throttle Cable
1-2mm Play
Stop Switch Wires
Cable Lug
Carburetor
Bracket
Slotted Fitting
Lock Nut
Recessed Hole
Cable Adjuster Sleeve
Clamps