Connecting Stop Switch Wires
Shaft Grlo
y
Stop Switch wires
/
Throttle Cable
1.
Install the plastic tube(packed with Engine Box)
around the throttle cable and stop swiroh wires.
2.
Plug the stop switch tenninal A into the matching
connector from the engine. Fix the stop switch
terminal B to the engine body with the screw
(packed with Engine Box).
Connecting Throttle Cable
1 . With air cleaner cover removed, Put two cable
a<liuster nuts(packed with Engine Box) on the end
of throttle cable .Slip the throttle cable through the
slot in the slotted fitting. making sure the cable lug
drops into the recessed hole. (See sketch)
Recessed Hole
Slotted Fitting
2.
Position the throttle cable in the throttle cable
bracket fix It with tightening the two cable acjjuster
nuts. Acjjust the cable position to keep 1-2mm play
between cable lug and slotted fittings. (See sketch)
3.
Operate the throttle trigger a few times to make sure
that it works correctly. Check the stop on the
carburetor throttle cam just contacts the throttle
Cable aqjuster
stop when the throttle trigger is fully depressed.
nuts
�0Screw
Terminal B
4.
When the throttle cable is adjusted correctly, tighten
two aqjuster nuts.
-8-
