MARUTI SUZUKI CELERIO, Руководство пользователя

Страница: 182 / 316

7-9
INSPECTION AND MAINTENANCE
76MH1-74E
Replace the Oil Filter
1) Using an oil filter wrench, turn the oil fil-
ter counterclockwise and remove it.
2) Using a clean rag, wipe off the mount-
ing surface on the engine where the
new filter will be seated.
3) Smear a little engine oil around the rub-
ber gasket of the new oil filter.
4) Screw on the new filter by hand until
the filter gasket contacts the mounting
surface.
54G092
(1) Loosen
(2) Tighten
Tightening (viewed from filter top)
82JN146
(1) Oil filter
(2) 1 turn
5) Tighten the filter specified turn from the
point of contact with the mounting sur-
face (or to the specified torque) using
an oil filter wrench.
Tightening torque for oil filter
1 turn or
14 Nm (1.4 kg-m, 10.3 lb-ft)
Refill with Oil and Check for Leaks
1) Pour oil through the filler hole and
install the filler cap.
For the approximate capacity of the oil,
refer to the “CAPACITIES” item in the
“SPECIFICATIONS” section.
2) Start the engine and look carefully for
leaks at the oil filter and drain plug. Run
the engine at various speeds for at
least 5 minutes.
3) Stop the engine and wait about 5 min-
utes. Check the oil level again and add
oil if necessary. Check for leaks again.
(1)
(2)
EXAMPLE
NOTICE
To tighten the oil filter properly, it is
Important to accurately identify the
position at which the filter gasket
first contacts the mounting surface.
(1)
(2)
EXAMPLE
NOTICE
To prevent oil leakage, make sure
that the oil filter is tight, but do not
over-tighten it.