7
Recommended tools:
•
Stud finder
•
Sharp pencil or pen
•
Pushpin
•
Dry wall knife/saw
•
Wire strippers
•
Phillips screwdriver or electric drill and bit
•
Tape measure
•
Low-tack tape
1. Using a stud finder, position the template
completely between wall studs or ceiling
joists.
2. Hold or pin the template in place and mark
cutout with a pencil.
3. Remove the template and cut out the opening
with a drywall knife/saw.
4.
In-wall:
Place fiberglass insulation above
and below the cut-out hole. Place a half
thick piece of fiberglass insulation behind
the speaker.
In-ceiling:
Place fiberglass
insulation 12” (30cm) or thicker between the
joists directly above the speaker.
5
Connect speaker cable. Be consistent when
connecting speaker leads to the terminals on
the speaker. Take great care to assign the
same color to the (+) terminal on both the
speaker and the amplifier.
WARNING!
Turn your amplifier
off before making or breaking any
signal connections!
6
Place speaker in hole.
7
Use a 2-inch long #2 Phillips driver and
an electric drill to lock all mounting locks in
place. Use a low clutch setting on the drill.
8
Gently press the grill cover into place.
Fig. 8
ElectroMotion
IW
Fig. 9
ElectroMotion
R
