19
How do I clean my speaker?
Use a dust free cloth (such as a micro fiber cloth)
or a soft brush to remove dust from your speakers.
Do not spray any kind of cleaning agent on or in
close proximity to the drivers.
Can I use other cables other than those
provided with the speaker?
The cables included with the speaker are intended
to get you started. You may find it necessary to
augment your system with additional cables or
replace the included cables with cables of differ-
ent length.
Could you suggest a list of suitable elec-
tronics and cables ideal for this speakers?
We have no favorites and use electronics and
cables quite interchangeably. We would suggest
listening to a number of brands—and above all
else—trust your ears. Dealers are always the best
source for information when purchasing additional
audio equipment.
Is there likely to be interaction between
my speaker and the TV in my A/V system?
Yes, but only with CRT televisions. This speaker is
not magnetically shielded and should be kept at
least two feet away from a CRT television. LCD
and plasma televisions will not be affected.
How can I remove the grille cloth from
the speaker?
Use a finger to firmly apply pressure to either corner
of the grille.
F
REQUENTLY
A
SKED
Q
UESTIONS
My speaker is not behaving as expected
•
Turn the speaker off using the Power button on
back of the speaker next to the AC input. Wait
thirty seconds and turn the speaker back on.
•
Unplug the speaker, wait thirty seconds, and
plug it back in.
•
Turn the speaker on and perform a factory
reset by inserting a pin or other small object
into the small hole above the “Reset” label on
back of the speaker. Using the pin, press the
recessed button for approximately five sec-
onds. When the factory default settings have
successfully been restored, the “Wi-Fi Setup
and Status” LED will briefly turn off, rapidly
blink green for approximately fifteen seconds,
and then begin blinking slowly green.
Front LED is flashing purple
•
The speaker is set to Wireless/Ethernet input,
but no network is detected.
•
If connected via an Ethernet cable, check to
make sure the cable is attached to a router
and that the router is functioning properly.
•
If connected via Wi-Fi, make sure your router is
on and functioning properly. Unplug your router’s
power, wait thirty seconds, and plug it back in.
•
Check to make sure your speaker is properly
configured to connect to your LAN and not
using a 5GHz network connection. Review the
section of the manual titled, “CONNECTING
TO A LOCAL AREA NETWORK (LAN).”
Speaker volume is not changing when
using a compatible Apple device or a com-
puter with iTunes (version 10 or later).
•
You may need to enable iTunes control
from remote speakers. Review the section of
the manual titled “CONTROLLING MUSIC
PLAYBACK USING ITUNES.”
•
Refer to the software’s documentation.
T
ROUBLESHOOTING
