Service and maintenance
15
Warning! Disconnect from power before cleaning.
Warning! Do not allow the product to become wet. Wipe with a damp cloth only.
To clean the product:
1. Disconnect the product from power.
2. Unclip both the fan grill covers on the rear panel from their holders and remove and clean the fan air
filters (see Figure 6).
3. Use a vacuum cleaner or low-pressure compressed air to gently remove dust and loose particles from
the outside of the product, paying special attention to the fan grills and air vents in the front of the
housing.
4. Reinstall the air filters and fan grill covers.
5. Wipe the outside of the product with a cloth lightly moistened in a mild detergent solution. Do not splash
with water. Do not use any product that contains abrasives or solvents.
6. Check that the product is dry before reapplying power.
Installing new software
It may be necessary to upload new software (i.e. device firmware) to the P3 PowerPort 1500 if it appears to
have a software-related fault or if you want to update to a newer software version.
Software for Martin™ products is available from the Martin website. The P3 PowerPort 1500 software can
be installed from the P3 System Controller over the P3 data link. See the P3 System Controller user manual
for software installation instructions.
Figure 6: Fan grills and air filters
