Martin Magnum 800, Руководство пользователя

Страница: 6 / 8

6
TROUBLESHOOTING GUIDE
All checks marked * must be carried out with the power supply disconnected from the
machine.
The inside of the machine contains parts at high temperature, always allow the machine
to cool before removing the cover.
Symptom Probable Cause Remedy
No LEDs come on when
power is applied to the
machine
•
Remote control not
connected
Connect remote to the DIN socket on
the top of the machine
•
Main power switch is
off
Switch on
•
Main internal fuse
open circuit
*Remove the cover and locate the
fuse on the PCB. Replace the fuse
with one of correct rating. (See Tech.
Spec)
•
Temperature sensor
open circuit
*Make a continuity check on the
sensor
The machine never
reaches operating
temperature (ready LED
never comes on)
•
An electronic or other
failure has occurred
in the heating system
Refer the problem to a service agent
•
The remote control or
its connections are
faulty
Replace the remote control
No smoke is produced
when the Fog button is
pressed
•
No fluid in the bottle Replace the bottle
•
The pump system is
not primed with fluid
Set the output level control to
maximum and hold down the Fog
button for 15 seconds
•
The output control is
not set high enough
Increase the output level setting
•
An electronic failure
has occurred
Refer the problem to a service agent
Never replace the internal fuse with one of a higher rating. If the fuse blows when
replaced, it means that there is a serious problem with the machine that should be
referred to a service agent.
Never operate the machine with the safety over-temperature trip disabled. If the trip
operates it means that the electronic control system has malfunctioned.