Martin MAC 101 Series, Руководство пользователя

Страница: 29 / 36

Display messages 29
Display messages
Message Appears when... What to do
RST
(Reset)
... the fixture is indexing effects at startup. Wait for reset to complete.
SRST
(Serial reset) ... the fixture has received a reset command.
Wait for reset to complete. Note that
you can set
PERSONALITY
→
DMX RESET
to
OFF
to prevent
accidental DMX reset commands.
MERR - MEMORY ERROR
...the EEPROM memory cannot be read.
Reset fixture.
Contact Martin if problem persists.
HTSE - HEAD TMP SEN ERR
...there is a malfunction in the head
temperature sensor circuit.
Contact Martin service for assistance.
LTSE - LAMP TMP SEN ERROR
...there is a malfunction in the LED
temperature sensor circuit.
Contact Martin service for assistance.
HTCO - HEAD TMP CUT OFF
...the head temperature sensor measures that
head temperature is too high. Power to the
LEDs is cut off.
Check that ambient temperature is not
too high. Check that the fixture is clean.
Check that there is free airflow around
the fixture.
Contact Martin service for assistance.
LTCO - LAMP TMP CUT OFF
...the LED temperature sensor measures that
LED temperature is too high. Power to the
LEDs is cut off.
FBEP - PAN FBACK ERR
FBET - TILT FBACK ERR
...there is a malfunction in the optical pan/tilt
monitoring circuit (e.g. sensor defective). After
a time-out, the effect in question stops in a
random position.
Reset fixture. Contact Martin service if
problem continues.
PSER - PAN SENSOR ERR
TIER - TILT SENSOR ERR
DRER - DRIVER CURR ERR
...there is a malfunction in the electrical
indexing circuit for pan, tilt or one of the
drivers. After a time-out, the fixture will
establish a mechanical stop, and continue to
work normally.
Reset fixture. Contact Martin service if
problem continues.
VOLT - VOLTAGE ERR
RAME - RAM ERROR
...there is a voltage or RAM error.
Reset fixture. Contact Martin service if
problem continues.
COLD - EFFECTS TOO COLD
...the onboard thermostat measures that the
effects are too cold.
Leave fixture powered on to warm it up.
Contact Martin service if problem
continues or fixture is warm.
FAN - FAN ERROR
...there is a fan or fan driver error.
Check that fan on rear of head is free to
rotate freely.
Contact Martin service for assistance.
COER - COLOR ERROR
...there is a driver error. Contact Martin service for assistance.
CCER - COLOR CALIB ERR
...color calibration data is invalid or
communication error.
Contact Martin service for assistance.
Table 6: Display messages