14
FIGURE 25
***STEP 11 CONTINUED***
SETTING THE ADJUSTMENTS
Before beginning
, confirm that the garage door is closed, the opener installation is
complete, the trolley is connected to the chain or belt connector, and the #8 LED is
illuminated showing that the power is on.
The adjustments
that can be made are Open Travel Limit, Close Travel Limit, Opening
Force, Closing Force, and the first Transmitter Programming.
REFER TO THE FOLLOWING TO PROGRAM OR CHANGE THE PROGRAM OF THE
MARTIN “SMART COMPUTER”:
TO PROGRAM
Press
and hold the "P" button for about 5 seconds. When all LEDs illuminate release the
button. See Figure 25
OPEN TRAVEL LIMIT
LED #2
should be blinking. Press and hold the "+" until the door is in the opened
position. Release this button. If the door is not in the desired position, press the "+" button
or the "-" button to move it slightly. Once the door is in the desired position, press and
release the "P" button. See Figure 26
CLOSE TRAVEL LIMIT
LED #4
should be blinking. Press and hold the "-” button until the door is in the closed
position. Release the button. If the door is not in desired position, press the "+" or the "-"
button to move it slightly. Once the door is in the desired position, press and release the
"P" button. See Figure 27
Attention! Do not close door tight on floor.
UP FORCE
LED #2 and #6
should be blinking.
Press and release the "+" or "-" button once. The
illuminated LEDs around the display will display the current force setting. By pressing the
"+" or "-" key, the force can be increased (+) or decreased (-). The force should be set as
low as possible. A suggestion is LEDs #1 and #2 should illuminate for one-car size doors
and LEDs #1, #2, #3 for two-car size doors. Once the desired force is selected, press and
release the "P" button. See Figure 28
BEGIN PROGRAMMING
FIGURE 27
FIGURE 26
OPEN TRAVEL LIMIT
FIGURE 28
COPYRIGHT © 2002 MARTIN DOOR
CLOSE TRAVEL LIMIT
UP FORCE
