NOTE: The feed is preset for 65# stock and typically does not require readjustment. Registration should
be set before setting the retarder for single sheet feeding.
Follow these steps:
1. Using the adjustment knob on the front of the feed shelf, position feed pres-
sure arm so that it is just above the feed wheel. Make sure there is no con-
tact. (Figure 10).
2. Using the adjustment knob on side of feed shelf, raise retarder off feed wheel.
Insert one piece of stock to be ran in between the retarder and feed wheel so that sheet passes freely.
Lower retarder so that there is a slight drag on the stock as it is pulled out.
3. Place a neat stack of three sheets into the unit and test. Readjust as necessary until one sheet feeds
steadily.
Feeding Thermographic or severely curled stock:
In some applications a hesitant feed can occur if the raise of the lettering prevents the sheet retarder from func-
tioning normally. This can also occur with heavier stocks should they develop a curl when printed.
Should this become an issue, the following steps can be performed:
1. Run stock through image side down.
2. Apply some weight to the stock for a period of time before it is to be run.
3. Use the 8.5" and 11.0" weights on top of the stack.
Should stock still have feed issues call technical support at Martin Yale Industries, Inc. at 260-563-0641.
Obtaining Service
Should your machine need to be professionally serviced, Martin Yale Industries, Inc. can refer you to the nearest
Factory Authorized Technician. Contact us at the phone number given above.
Factory standard accessories include scoring wheels and perforator wheels. Each component uses its own cut-
ting hub as an assembly. The components cannot be separated.
To engage the scoring roller, follow the instructions below:
1. Loosen the 3/32" Allen set screw in the lower back up hub.
2. Slide the scoring roller and hub to the appropriate location.
3. Retighten the setscrew in the back up hub.
NOTE: The scoring roller does not contain a setscrew. This component should be free spinning.
To engage the perforator wheel, follow the instructions below:
1. Loosen the 3/32" Allen set screw in the perforating wheel and in the backup hub.
2. Slide components to the appropriate location. Retighten both setscrews.
NOTE: THE BACKUP HUBS ARE NOT INTENDED TO BE SEPARATED FROM THEIR UPPER COUNTER
PART. DO NOT ATTEMPT TO SEPARATE THESE ITEMS.
NOTE: Positioning of the feed rollers to the scoring/perforating blade should be located at the left edge
and right edge of stock being used.
NOTE: OVERTIGHTENING OF SET SCREWS CAN CAUSE STRIPPING. WHEN TIGHTENING ACCES-
SORIES, SCREWS SHOULD BE APPLIED 1/8-1/16 OF A TURN PAST SNUG.
5.1
Proper Feeding
Pressure arm
should rest just out of
contact with the feed
wheel.
6.0 Accessory Function
Figure 10
4
Содержание Intimus SP100
Страница 7: ...BCS 410 412 SP100 Wiring Diagram 7 ...
