Control panel
15
2
To calibrate the zoom, select
U T I L / C A L / Z O O F
and press [Enter]. The default value of 128 can be
adjusted up or down to move the diffuser lens relatively forward or back. Make any necessary adjustments
and press [Enter] to save the setting.
3
To calibrate the color wheels to an offset from their mechanically indexed position, select
U T I L / C A L / C 1 O F
and press [Enter]. The default value of 128 can be adjusted up or down to move the
color wheel relatively forward or back from its indexed position. Make any necessary adjustments and press
[Enter] to save the setting. Repeat this procedure if necessary for color wheel 2 (C2OF).
4
To calibrate the optional dimmer wheel to an offset from its mechanically indexed position, select
U T I L / C A L / D I M W
and press [Enter]. The default value of 128 can be adjusted up or down to move the
dimmer wheel relatively forward or back from its indexed position. Make any necessary adjustments and
press [Enter] to save the setting.
5
Pan calibration is most useful when multiple fixtures are stacked vertically. To calibrate, set zoom, iris, and
tilt position for easy one-over-the-other comparison and set each fixture to the same pan DMX value. Select
one fixture to be the reference fixture. On the other fixtures, select
U T I L / C A L / P O F
and press [Enter].
Adjust the offset as necessary to align the beam with the reference beam. Press [Enter] to save the setting.
6
Tilt calibration is most useful when multiple fixtures are arranged horizontally. To calibrate, set zoom, iris,
and pan position for easy side-by-side comparison and set each fixture to the same tilt DMX value. Select
one fixture to be the reference fixture. On the other fixtures, select
U T I L / C A L / T O F
and press [Enter].
Adjust the offset as necessary to align the beam with the reference beam. Press [Enter] to save the setting.
7
To calibrate the dimmer, select
U T I L / C A L / D O F
and press [Enter]. Hold a piece of paper over the
lens. Set the offset to 0 and then increase it until light is clearly projected onto the paper. Press [Enter] to
save the setting. Remove the paper.
8
To calibrate color mixing flags (cyan, magenta, yellow, and color temperature correction), project white
beams with no dimming and position them for easy comparison. On each fixture,
including the reference
,
select
U T I L / C A L / C O F
and press [Enter]. (This adds a defined amount of cyan.) Select one fixture to
be the reference. Adjust the offsets on the other fixtures to match the reference color. Press [Enter] to save
the setting. Repeat for
M O F
(magenta),
Y O F
(yellow), and
C T O F
(CTC).
Software upload
The software update mode is normally engaged automatically by the upload device. If this does not occur,
see “Firmware installation” on page 27.
Содержание MAC 2000 Wash
Страница 1: ...MAC 2000 Wash user manual...