B. Setpoints
1. Storing Setpoints
The setpoint mode allows up to 9
setpoints to be set in non-volitile memory
for each range. The procedure is as
follows:
a. Set the output to the desired value.
b. Press shift followed by the “SET” key
c. Choose the desired setpoint storage
location by pressing a key (1-9).
d. Enter a new value and repeat steps 1
through 3 as needed, up to 9
setpoints for each range can be
stored.
2. Recalling Setpoints
a. To recall a setpoint press shift followed
by the”SPT” key.
b. You will be prompted to enter the
number of the desired setpoint
location set previously.
c. Press the desired location number and
the unit will go to that output.
3. Automated Stepping
The PTC8001 can auto-step through
some or all of the stored setpoints for a
given range. The procedure is as follows:
a. Press “Shift” followed by “Auto”.
b. “Auto SPT ?” will appear. Enter the
ending setpoint location. Example: if
you have all 9 setpoints stored but
only want to step through the first 3
then enter ”3” for this question.
6
