E: [email protected] | P: 02 8778 7500
www.martecaustralia.com.au
WARNING
Installation MUST carry out by a qualified and licensed electrician.
How to Install Blades
How to Install / Remove the Cover
Connect the 2-pin
connectors from motor
housing with the light kit
plate.
Install the light kit plate
to the motor using screw
provided.
Slot the metal
cover into
the light kit. (See Fg.6)
CCT (Colour Changeable Temperature)
Fg.8
NB: Ensure the blades do not get damaged or bent during the
installation process while the fan maybe on the ground, this will affect
the performance and balance of the fan and this is NOT covered under
warranty.
Attach the blade to the top of the motor. Tighten and secure blade
with screws and washers provided. Repeat this procedure until all
blades are installed. (See Fg.5)
Fg.5
Choose colour temperature by flicking the switch in the LED
(See Fg.7)
C = 5000K cool white
N = 4000K neutral white
W = 3000K warm white
Dimming
The SCORPION ceiling fan has a smart 3 step dimming LED light module which doesn’t require a dimmable remote control or a wall
dimmer. It only requires a remote control kit supplied with the product.
Turn the switch on and the light will turn on. Flick the switch on/off within 1 second and the light output will dim down to approx. 50%.
Flick the switch on/off again and the light output will dim down to approximately 15%. The light kit has NO memory function, it will turn
on at 100% initially.
Fg.6
Model shown with light
Model shown fan only
Model shown fan only
Install the metal
cover into
the light kit. (See Fg.7)
Fg.7