6 of 12
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
WS2643
DEPTH ADJUSTMENTS
The blade should be set so it cuts into the plastic blade
stop (D) when the handle is pressed down.
To set the blade depth, rotate the two large nuts (E) on
the underside of the base with a 11/2" (38mm) wrench.
Ensure that both are turned an equal amount.
Adjust in quarter turn increments and check to see how
deep the blade is set.
To open the blade to cut 1" material, loosen the
Back Stop Knob (F) and rotate the Back Stop (G) up.
THE ANVIL
The anvil has two edges: a 1/32" (0.75mm) narrow edge
and a 3/16" (4.5mm) wide edge. Either edge can be used
according to the support needed to make a clean cut.
Some soft-backed products require the wider anvil
edge.
TO CHANGE BETWEEN ANVIL EDGES
Simply remove the anvil screws and flip the anvil over.
Ensure blade stop is in place.
ADJUSTMENTS
TABLE
I-BEAM
ANVIL
B
L
ADE
B
L
ADES
TOP
TABLE
I-BEAM
ANVIL
BL
ADE
BL
ADES
TOP
TABLE
I-BEAM
ANVIL
BL
ADE
BL
ADES
TOP
TABLE
I-BEAM
ANVIL
B
L
ADE
B
L
ADES
TOP
E
BACKSTOP DOWN
D
D
E
D
BACKSTOP UP
F
F
G
NOTICE
Approved materials may vary in density and hardness. If extreme pressure is required to cut a product, it
may result in damage to your machine. Please contact MARSHALLTOWN Tools before proceeding.
Warranty is void if an unapproved product damages the machine.
!
!
NOTICE
DO NOT CUT HARDWOOD WITH THIS SHEAR!
!
!
G