Quick Setup Tech-note using VS-PTC-150 (Controller) with CV620 (Camera)
1. Unpack CV620 (Camera) and VS-PTC-150 (Controller) and plug in power sources.
2. Use
RS-232
Cable packed in VS-PTC-150 (Controller) box and plug in VGA-style comm cable with thumb
screws to (Controller) and plug round 8-pin connector to CV620 (Camera).
3. Confirm (Controller) is set to CAM: 001 on LCD Screen, or 002, 003, 004
matching
ADDRESS of Camera.
Also confirm both Controller and Camera are set to VISCA or PROTOCOL V.
4. Or use
RS-422
wire harness on VS-PTC-150 (Controller) and CV620 (Camera) and plug 2 wires into each
end using one wire to connect from Controller (position #1 – Ta) to Camera (position #6 RXD IN -), then
connect other wire to connect from Controller (position #2 – Tb) to Camera (position #7 RXD IN +).
VS-PTC-150 Controller
CV620 Camera
5. Confirm (Camera) is set to ADDRESS SELECTOR (Camera-ID) #1 position on back panel, or #2 ~ #7.
