Marshall Electronics
5
Electrical Specifi cations
Display (Viewing Area)
7” (6.14”H × 3.27”V) (156.0mm x 83.28mm)
Viewing Angles
130°H x 120°V
Resolution (RGB Dots)
800H x RGBx480V (1.2 million pixels)
Contrast Ratio
400:1
Color temperature
D65 (65000 Kelvin)
Dot Pitch
0.163 mm
Pixel Response
30ms average
Screen Refresh Rate
50/60 Frames per second
Brightness
400 cd/m²
System
NTSC/PAL auto recognition via SDI
Inputs
HDSDI/SDI with re-clocked output (BNC)
6
Mechanical Specifi cation
Dimensions
7.44”W x 5.0”H x 2.5”D (18.89cm x 12.7cm x 6.35cm)
Approx. Weight
3 lbs
Power Consumption
12VDC, 9.6Watt nominal, 3.0Amps max - UL Class 2 (supply included)
7
Faceplate Cleaning
When cleaning the faceplate it is very important to use non-abrasive and ammonia free cleaning agents and a clean
micro fiber clothe, or cheese clothe. Do not use paper towels. Paper towel fibers are coarse and may scratch the sur-
face of the Polycarbonate faceplate. Paper towels may also leave streaks on the surface. Antistatic and fingerprint
resistant cleaning agents are recommended.
V-R70P-HDSDI shown with V-LCD4-MT camera hot shoe mount attached plus rear mount
confi guration of V-R65-BA adaptor and IDX-E50S battery
IDX-E50S
V-R70P-HDSDI shown with V-H700P hood attached
4
V-R70P-HDSDI
Users Guide
1. Unpack the V-R70P-HDSDI and accompanying power supply. Physically inspect for any damage that may have
occurred during shipping. Should there be any damage, immediately contact Marshall Electronics at 800-800-6608.
If you are not located within the continental united states call +1 310-333-0606.
2. Connect required cables for signal input and output.
Please note that power must be applied to the V-R70P-HDSDI for the HDSDI/SDI outputs to be activated. All BNC
connectors should be rated for 75
Ω
.
3. Plug the power supply into the A.C. source
Please note that power can be supplied from a variety of DC sources, such as batteries or Vehicle power. Input
power range is 10.7 to 15 Volt D.C. In operation, the V-R70P-HDSDI will draw approx. 0.8 amp.
Attach twist lock power connection from V-PS12-V-5 power supply to the back of the unit.
4. Turn on the V-R70P-HDSDI by depressing the power switch located on the front of the unit.
8
Operational Setup
* Tally lamps active when connected to ground
HDSDI or SDI in.
270Mbs to 1.5Gbs
Automatically terminates to 75
Ω
Refer to Table 3 for signal types
Re-Clocked
HDSDI/SDI Output.
Signal in equals
signal out
10.7 to 15 VDC.
V-PS12-V-5 power supply is included
Left Pin - Pos
Right Pin- Neg
Input Connectors
9
5
Pin1- Green
Pin2- Red
Pin3-Amber
Pin4 Gnd -
Pin5-
Pin6-
Pin7-
Pin8-
Pin 9-
Pin10-
Pin11-
Pin12-
Pin13-
Pin14-
Pin15-
Tally IN DB-15 Female
