Module Installation
Input / Output Module Installation
The ARDM-series input and output modules are designed for simple installation and removal without tools. Use the
following instructions to install a module:
1. Ensure that the audio monitor is powered off.
Modules cannot be installed or “hot swapped” while the audio monitor
is powered on.
2. Remove the blank cover if present over the empty slot using a Philips screwdriver with appropriate head size.
3. Carefully slide the module into the open slot, aligning the side edges of the module with the guides inside the
monitor. Push the module all the way in until it locks into place.
4. Tighten the two thumbscrews on the face of the module.
The following diagram shows module installation in a 1RU audio monitor model, which also applies to all 2RU models.
Note:
Avoid touching components inside the module to prevent static discharge
THUMB SCREWS
EMPTY SLOT
COVER
