OWNER’S MANUAL
MODEL HST13 – AUTOTOAST™ VERTICAL TOASTER
135168CH7 RV111109
1
Copyright
©
2009 Marshall Air Systems, Inc.
All Rights Reserved.
PRE-INSTALLATION
1. The toaster is packaged to minimize the risk of shipping damage. Immediately upon receipt,
make certain to inspect the unit for damage.
FILE ALL CLAIMS WITH THE FREIGHT CARRIER.
2. Unpack unit and remove all protective paper or plastic from metal parts.
FILE ANY CONCEALED DAMAGE CLAIMS WITH THE FREIGHT CARRIER.
3. This toaster is shipped wired and ready to plug into a grounded NEMA L6-20R amp receptacle.
(208 Volt Single Phase, 3 wire including the ground circuit). Check receptacle for proper voltage
and phase. Units which are 240V single phase international are shipped with no electrical plug.
INSTALLATION
1. It is necessary to seal bottom of toaster to the countertop using NSF listed silicone sealant.
2. Check that the two lift off side covers are in place on the toaster
AND THE LEFT COVER IS
SECURED WITH A SCREW AT THE BOTTOM.
3. Check that the toaster platen sheet is installed over the contact platen. The toaster platen sheet is
installed from the top of the unit by lightly creasing it at the center, and directly hanging it on the
center platen.
USE ONLY MARSHALL APPROVED PLATEN SHEETS OR TOASTER
WARRENTY IS VOID.
4. Install the bun guide assembly on the toaster. (Figure 4)
5. Connect the toaster to the power supply.
6. Turn on the power switch and check for free movement of the two conveyor belts. If unit is
equipped with LED control, display will read “Lo.”
7. Unit is ready to used in approximately 15 minutes. LED control will display “Rdy.”
8. After warm up, drop buns into the toaster at the top of the unit. For proper operation, insert heels
on the side of the toaster marked "Heel", and crown on the opposite side.
THE CUT SIDES OF
THE HEEL AND CROWN MUST FACE EACH OTHER. DO NOT USE PRE-BUTTERED BUNS
WITH THIS TOASTER.
9. The toasted heel and crown will drop down onto the product slide together. Check the
appearance of the toasted buns.
10. Adjust the gap settings using the two levers inside the right panel. (See Figure 8). The levers are
labeled “HEEL” gap and “CROWN” gap. To adjust the gap, loosen the black adjustment knob
(Figure 8), several turns to disengage the threaded rod from the locator holes. Turn the lever to
the desired position and retighten the black knob so that the threaded rod engages in one of the
locator holes.
11. The speed control is located behind the left side cover of the CH7, CH7B toasters only.
DISCONNECT (UNPLUG) THE POWER BEFORE OPENING THE SIDE COVER.
The speed
control can be adjusted to control the conveyor belt speed to lighten and darken the toasted
product. The toaster is shipped with the speed control set for a twelve-second toast. Models
