SOLO-IDEA
INSTALLATION MANUAL
Page 11
9.1.3
CONTROLING OUTPUTS WITH DTMF
SOLO-IDEA can control the outputs with the use of DTMF. This is very useful function in the
intercom application.
To control the outputs the user must press the combination of 2 digits. First digit is used to select
the output (1 to 2), the second digit is used to activate (1) or deactivate (0) the output. There is a
special case when the user can select for first digit (output selection) number 0. In this case all
outputs control by the same time.
Combination must be pressed in 2s interval, and must be 3s apart to be valid.
NOTE
SOLO-IDEA must be in voice connection to support DTMF output control!
Example:
DTMF combination
Description
00
Deactivate ALL outputs
01
Activate ALL outputs
11
Activate output 1
10
Deactivate output 1 (if in latching mode)
21
Activate output 2
20
Deactivate output 2 (if in latching mode)
Table 5: DTMF control example
9.2
OUTPUT MANAGEMENT
SOLO-IDEA supports the possibility to report alarms from inputs and any other events locally via 2
outputs. The behavior is defined using next parameters
9.2.1
OS parameter
SOLO-IDEA device has 2 dedicated relay supported outputs. Outputs can be configured to different
behavior:
OS = 0
– Disabled
OS = 1
– Bi-stable toggle mode
OS = xxx
– Mono-stable pulse mode (duration in seconds)
Typical connection for the output:
R=1k
Ω
LED
Output 1-2
+12V DC
RELAY
12VDC
Output 1-2
+12V DC
Figure 3
:
Output Connection diagram
