Marquis Solara MQZDV3318, Руководство по установке

Страница: 21 / 49

3318 / 3622 Door and Glass Information
Glass Cleaning
It will be necessary to clean the glass periodically. During start-
up, condensation, which is normal, forms on the inside of the
glass and causes dust, lint etc. to cling to the glass surface.
Also, initial paint curing can deposit a slight film on the glass. It
is therefore recommended that initially the glass be cleaned
two or three times with non-abrasive common household
glass cleansers and warm water. After that, the glass should
be cleaned two or three times a season depending on the
circum- stances.
Glass Replacement
REPLACEMENT GLASS FOR DIRECT VENT UNITS
Model Series
ZDV3318 & ZDV3622 can use either
tempered glass or Robax ceramic or coated
Neaoceram glass. Must be 5mm thick.
Model Series
ZDVRB3622 must use tempered glass.
Must be 5mm thick.
To replace glass, clean all materials from door frame.
Scrape off old silicone down to metal. Using a high heat
silicone temperature-resistant to 500°F (260°C) apply a
continuous bead of approximately 1/4” to all four sides
of frame and insert glass with new gasket. Frame
should be on flat surface,
with a small amount of weight pressing glass into
silicone. Let dry approximately 15 to 20 minutes. The
door can be re-installed by reversing Steps 1 & 2. Use
caution when removing broken glass, wear gloves.
Removal of the Glass Door- ZDV3318 &
MQZDV3318 :
1. Unlatch the two latches located behind the upper
grill.
2. To remove, pull frame forward and lift from bottom
door retainer.
Removal of the Glass Door -
ZDV3622,ZDVRB3622, & MQZDV3622:
1. Remove the door by unlatching the 2 top latches.
Simply place 2 fingers in the grooves, pull towards
you and lift upwards slightly.
2. Once the top of the door is unlatched, simply pull
outwards and lift upwards to unlatch the bottom.
3. When re-installing the door place the bottom of the
door in first and secure with Top Latch assembly to
the door.
!
WARNING AND CAUTIONS.

Do not clean when the glass is hot.

Do not use abrasive cleaners.

Using a substitute glass will void all product
warranties.

Do not strike or abuse glass. Care must be
taken to avoid breakage of the glass.

Do not operate this fireplace without the glass
front or with a broken glass.
Spring Replacement- ZDV3622,ZDVRB3622,
& MQZDV3622:
*Over time, spring may need to be replaced if tension is
lost.
1. To remove the top latch, remove the 2 hex screws
that secure it in place. They are located in the
firebox
2. Once all the screws are removed the latches will
slide out of place.
3. There is 1 lock nut per latch. When replacing a
spring, tighten the lock nut until 2 threads are
beyond the locknut. This is critical for proper tension.
3318 Door
Latch
Finger Grooves
3622 Door Latch
Spring Part # 36HB-123
Top Hooks
2 Hex Screws
21