6
Page
3. Placement
of
the
Windlass:
a. Place the windlass on the deck and find a suitable position for it,
with reference to the vessel’s bow roller, rope and chain locker be-
low.
b. Place the mounting template on the deck in the desired position for
the windlass and hold it in place using adhesive tape.
c. Use a 3/8” (10mm) diameter drill to make four holes for the mount-
ing thread rods and make a fifth hole to pass power supply cables
bow roller
bow roller
bow roller
bow roller
gypsy
gypsy
gypsy gypsy
windlass
windlass
windlass
windlass
CORRECT CORRECT CORRECT
INCOR-
Note: Placement of the windlass is important
to correct operation. If unfamiliar with this
product and installation, seek a professional
d. With a jigsaw, cut the hole for the rope and chain to pass through.
Use a file to smooth any rough edges. To avoid water absorption by
the deck, apply paint to the cut hole edges.
e. Secure thread rod to the base of the windlass, then apply a silicone
sealant around thread rod. Secure the windlass firmly to the deck
from below using the nuts and washers supplied.
f. Apply silicone sealant (Marpac 7-2505 or 7-2507 is recommended)
around the outside of the base.
g. Mount control device at a suitable position either in the cabin or
close to the operating area.
Verify all markings for mounting location prior to
