13
1.
Perform any measurement as described in the operating instructions.
2.
Press the RELATIVE button to store the reading in the display and the
"
REL
" indicator will appear on the display.
3.
The display will now indicate the difference between the stored value
and the measured value.
4.
Press the RELATIVE button to return to normal operation.
DC VOLTAGE MEASUREMENTS
CAUTION:
Do not measure DC voltages if a motor on the circuit is
being switched ON or OFF. Large voltage surges may occur that can
damage the meter.
1.
Set the function switch to the V DC position (“mV” will appear in the
display).
2.
Insert the black test lead banana plug into the negative (COM) jack
and the red test lead banana plug into the positive (V) jack.
3.
Touch the test probe tips to the circuit under test. Be sure to observe
the correct polarity (red lead to positive, black lead to negative).
4.
Read the voltage in the display. The display will indicate the
proper decimal point and value. If the polarity is reversed, the
display will show (-) minus before the value.
