11-5. Transmit The Data Logger
You can transmit the stored temperature to pc. The function can only be
used when the unit is in LOG mode, and it can transmit all of the stored
temperature one time. The function works as follows:
While in LOG mode, press the trigger and then press the
“down”
arrow
button until reach LOG
“TrM”.
When LOG location “TrM” shows in the display, press “laser/backlight”
button. A tone will sound and the LOG location will automatically change
to “1”, all of the stored temperature transmit to pc.
11-6. Wireless Transmit Function
In the MAX, MIN, DIF, AVG mode, press the
“USB”
button to stir up
the Wireless Transmit function,
“USB”
will be displayed on the upper
right corner of the LCD.
Press the USB button again; this function will be turned off.
After the Wireless Transmit function is turned on, firstly connect the USB
interface (RF 433MHz) to the computer and wireless transmitter and open
the software on the computer, then the IR temperature readings on the
Thermometer will be transmitted to the computer.
Wireless Transmit is allowed to use within a 30m area.
Note:
Data will only be transmitted under SCAN state.
Note: Measurement considerations
Holding the meter by its handle, point the IR sensor toward the object
whose temperature is to be measured.
The meter automatically compensates for temperature deviations from
ambient temperature. Keep in mind that it will take up to 30 minutes to
adjust to wide ambient temperatures are to be measured followed by high
temperature measurements, some time (several minutes) is required after
the low (and before the high) temperature measurements are made.
This is a result of the cooling process, which must take place for the IR
sensor.
