MARMON Prince Castle Silver King SKMCD1P/C1 Скачать руководство пользователя страница 9

36132-EN

9

Printed in USA 10/13 © 2013

Cream Dispenser

Model SKMCD1P/C1

P

RINCE

 

C

ASTLE

 

LLC

 

W O R L D W I D E

RISK OF ELECTRIC SHOCK! Always unplug the power cord before servicing the unit to avoid electric shock.

Troubleshooting Guide

WARNING

PROBLEM

PROBABLE CAUSE

SOLUTION

Compressor will not run

No voltage at wall receptacle 

Check circuit breaker or fuse.

Service cord pulled out of wall receptacle  Replace.

Low voltage causing compressor to cycle 
on overload 

Contact power company and confirm that voltage fluctuation 
does not exceed 10% plus or minus from the nominal rating. 

Power switch is in “Off” position 

Turn switch on.

Inoperative control 

Call for service (888-375-2938).

Compressor stuck

Call for service (888-375-2938).

Compressor windings open

Call for service (888-375-2938).

Compressor overload stuck open 

Call for service (888-375-2938).

Relay lead loose 

Call for service (888-375-2938).

Relay loose or inoperative 

Call for service (888-375-2938).

Power cord disconnected from dispenser

Call for service (888-375-2938).

Faulty cabinet wiring 

Call for service (888-375-2938).

Compressor runs but no 
refrigeration 

System out of refrigerant

Call for service (888-375-2938).

Compressor not pumping 

Call for service (888-375-2938).

Restricted filter drier 

Call for service (888-375-2938).

Restricted capillary tube

Call for service (888-375-2938).

Moisture in system 

Call for service (888-375-2938).

Compressor short cycles 

Erratic control thermostat

Call for service (888-375-2938).

Faulty relay

Call for service (888-375-2938).

Low voltage

Contact power company and confirm that voltage fluctuation 
does not exceed 10% plus or minus from the nominal rating.

Compressor draws excessive wattage 

Call service technician. 

Compressor runs too much or 
constantly 

Temperature too low 

Adjust temperature control.

Erratic control

Call service technician.

Abnormally high room temperature 

Reduce room temperature or relocate dispenser. 

Door or lid gaskets not sealing

Adjust or call for service (888-375-2938).

System undercharged due to leaks

Call for service (888-375-2938).

System undercharged from factory

Call for service (888-375-2938).

System overcharged

Call for service (888-375-2938).

System not clean

Call for service (888-375-2938).

Restricted filter drier

Call for service (888-375-2938).

Restricted capillary tube 

Call for service (888-375-2938).

Noisy

Tubing vibrates

Call for service (888-375-2938).

Internal compressor noise 

Call for service (888-375-2938).

Compressor vibrating on cabinet frame 

Call for service (888-375-2938).

Beverage leaking or not 
flowing 

Tube kinked 

Remove valve and pull tube straight through valve area.

Valve stuck 

Clean valve and valve area or call for service (888-375-2938).

Содержание Prince Castle Silver King SKMCD1P/C1












Отзывы: