HOW TO INSTALL POWERMID
PLUS
Description of POWERMID
PLUS
The POWERMID
PLUS
kit consists of an 8 in 1 Remote Control and a POWERMID receiver. The 8 in 1 Remote
transmits RF signals through walls and floors. The POWERMID receiver converts the commands of the 8 in 1
Remote into infrared signals to control your equipment in other rooms.
With the 8 in 1 Remote it is possible to control your equipment in line of sight as well as remotely through the
POWERMID receiver. Therefore, it is possible to control e.g. the bedroom TV and the VCR in the living room at the
same time.
How to install the POWERMID receiver
Plug the POWERMID receiver into a 230V / 50 Hz outlet in the room where your VCR, Satellite Receiver, Stereo etc.
is located (within 6 meters / 20 feet in line of sight). Point the front of the receiver (POWERMID label) towards your
equipment. Extend the antenna fully.
The distance between the 8 in 1 Remote and the POWERMID receiver can be 15 to 25 meters (30 to 80 feet),
depending on local circumstances.
In case you cannot place the POWERMID receiver in line of sight with your equipment, or in case your equipment is
located in a closed cabinet, add an Infrared Extender (sold separately: MARMITEK INFRARED EXTENDER single:
RX569, Art. No. 08917, double: RX570, Art. No. 08920).
Add more receivers to control equipment in multiple rooms.
Please refer to the enclosed 8 in 1 User Instruction Guide for setting up the 8 in 1 Remote. No extra set-up
procedure is needed for using the 8 in 1 Remote with the POWERMID receiver. The Remote transmits infrared
commands as well as RF commands at the same time. Therefore it is possible to set-up and test the 8 in 1 Remote
by using it in line of sight with your equipment and test it with the POWERMID receiver afterwards.
Note: The POWERMID
PLUS
is not suitable for use with B&O equipment
970902