Marmitek EASYTOUCH ET35, Руководство пользователя

Страница: 15 / 98

15 EASYTOUCH 35
4. Pressing the Setup key twice allows for the User to abort and exit the Macro routine.
First Setup keypress takes you to the "Delay" screen and the second Setup press
results in abort and exit.
5. It is not possible to include a Macro within a Macro.
To Delete a Macro:
1. Press and hold the Setup key until the LED remains on (occurring after approximately
2-3 seconds) and the display shows Main Setup Screen.
2. Release Setup key.
3. Press and hold either the Touchscreen or rubber MACRO key. The LED will blink off to
indicate the keypress acceptance and the Macro Delete Setup Screen will be shown.
Only set Macros will be shown.
4. Press and release the digit key for the Macro that is to be deleted. The LED will blink
off and the Macro is deleted. Use the EXIT key to abort if required.
5. Macro deletion is now complete.
11 Channel toggle key
The Channel-Toggle "P<P" key is a special form of Macro key. The feature allows you to
program in two specific channels and switch between them with a single key-press. For
example, you may want to switch between TV channels 123 and 456. Programming the
"P<P" key will allow you to do this.
Two sets of data are to be entered. Each set of data can be up to 4 key-presses and must
be a minimum of 2. The first keypress in each set must be a Mode key. The following
keystrokes can be any other key (except for Mode, Macro, Setup and Screen) although in
practice, these keys will usually be digit keys. Note no "shifted" commands can be part of
a "P<P" sequence and a SCREEN keypress counts as a keystroke.
To Program the Channel-Toggle Feature:
1. Press and hold Setup key until the LED remains on
(occurring after approximately 2-3 seconds) and display shows
the Main Setup Screen.
2. Release Setup key.
3. Press and release the Touchscreen "P<P" Key.
ENGLISH
easytouch35_manual ok 6/17/03 10:30 AM Page 15