Marlec Eng Co Ltd Installation Instructions
_________________________________________________________________________________________
_
Document No: SM124 Issue D 30.01.07
3
•
The Windcharger is fitted with ceramic magnets, which can be damaged by
heavy handling. The main generator assembly should be treated with care
during transit and assembly.
•
It is essential to observe the correct polarity when connecting the
Windcharger and all other components into an electrical circuit. Reverse
connection will damage the Windcharger and incorrect installation will
invalidate
the
warranty.
•
The fuse supplied must be fitted to protect the system unless used in
conjunction with a controller that is already fitted with a charge fuse.
•
High winds – in high winds the Windcharger’s built-in thermostat may
operate to prevent the generator overheating. In this mode the output will
cease and the turbine will temporarily slow down until such time as the lower
level temperature is reached and the generator is once again connected and
charging. This may be seen to cycle in prolonged high winds particularly in
high ambient temperatures. Further the furling tail mechanism of the
Furlmatic model will operate in high winds orienting the turbine out of the
prevailing wind direction to slow the turbine down. It will return to face the
wind as windspeeds fall and will be seen to cycle during high wind speeds.
•
If in doubt, refer to your dealer, a competent electrical engineer or the
manufacturer.
