9
DCC
CV Meaning
Values
1 Address, lower value
Byte
0-255 (1)
7 Manufacturer version
number (software
version)
(-) read only
8 Manufacture recognition
ID Decoder reset
(131)
8 (-)
read only,
factory setting, value
is not written
9 Address, higher value
Byte
0-7 (0)
29 Configuration
(192) read only
Bits 0-4 are not used
0
Bit 5: Decoder type
0 / 32 basic or advanced
accessory decoder
Bit 6: Addressing method
0 / 64 decoder or output
address
Bit 7: Decoder type
128 accessory decoder
36 Turnout lantern, off/on
0-1 (1)
Setting and generating addresses larger than 255:
Example: Address 1044 -> 1044:256=4,078125 . The value before
the comma (4) is to be entered in CV 9. The value after the com-
ma (0,078125) is multiplied by 256, 078125x256=20. The value of 20
that is generated must be entered in CV 1.
Operation with mfx
mfx registration can be done with MM or DCC.The mode of ope-
ration that has been set by means of Dip Switch 10 is critical.
The mfx registration is initiated with the 60213/60214/60215 CS2
in > and with the 60216/60226 CS3 in the solenoid item
configuration by means of >“search for mfx item“.
Note about mfx registration with the CS2:
Selection possibility „Automatically assign solenoid item“ at
„Setup“ > > „Track“.
If the check mark there is checked, the mfx registration is done
at the first open address in the CS2. If the check mark is not
checked, the mfx registration is done at the address actually
programmed on the decoder.
