3
INSTALLATION
Assembly to Stand or Legs
CAUTION
Before connecting water to this unit, have
water supply analyzed to make sure hardness
is no greater than 2.0 grains and pH level is
within the range of 7.0-8.5. Water which fails
to meet these standards should be treated
by installation of a water conditioner. EQUIP-
MENT FAILURE CAUSED BY INADEQUATE
WATER QUALITY IS NOT COVERED UNDER
WARRANTY.
NOTE: Details of other electrical systems available upon
request. Consult Factory.
ASSEMBLY OF LEGS OR STAND
Tools Required
• 1 3/16’ Allen Wrench
• 1 One foot ruler
• 1 Screw Driver
Remove all parts from box
STAND
• 4 legs (27”)
• 4 leg tops
• 4 cap brackets
• 8 lock washers
•
8 flat washers
• 8 round head screws (1/4-20)
• 1 shelf
• 4 set screw (in shelf)
STAND
• 4 legs (4”)
• 4 leg tops
• 4 cap brackets
• 8 lock washers
•
8 flat washers 8 round head screws (1/4-20)
Assemble unit as follows:
NOTE: For assembly to stand follow steps 1 through 9.
For assembly on legs follow steps 4 through 9.
1. Insert four legs in shelf from top down (1).
2. Measure 12” from bottom of leg to top of shelf in all
four positions (2).
3. Tighten set screw securely once shelf is level.
4. Screw four leg tops on four legs (
with or without shelf
)
until they are all the way down.
5.
Ascertain that tops on all leg tops are equidistant from
the floor or counter.
6.
Screw cap bracket (6) on to threaded fitting in leg top.
Be sure threaded holes are all on the outside.
7. Tip steam-it on it’s back.
8. Place stand on legs in frame (7) of steam-it (8), mak-
ing sure that slot (9) in frame matches holes in cap
bracket (6).
9.
Insert lock washer and then flat washer (10) on round
headed screw (11) and insert loosely in slot and
threaded hole (
8 positions
). Tighten all screws (11).
Figure 1
