Master/slave-operation
The master/slave-operation enables that several devices can be synchronized and controlled by one
master-device
DMX controlled operation
You can control the projectors individually via your DMX-controller
Addressing
The control board allows you to assign the DMX starting address,
Note;it’s necessary to insert the XLR termination plug (with 120ohm) in the last device in the link in order
to ensure proper transmission on the DMX data link.
C O NT R O L B O AR D
The control board offer several features :you can simple set the starting address, run the
pre-programmed program or make a reset
The main menu is accessed by pressing the Mode/Esc button, Browse through the submenu by pressing
Up or Down .Press the Enter-button in order to select the desired menu. You can change the selection
by pressing Up or Down, Confirm every selection by pressing the Enter-button. You can leave every
mode by pressing the Mode/Esc-button .The functions provided are described in the following setting.
M EN U M AP
DMX Address
(DMX address 001-512)
Mode
(DMX mode 15 ch, Auto mode1~8,sound mode)
TEST mode
(X,Y,Red,Green,Blue,White)
Setting
(ID code0-25,X reverse,Y reverse,Fade delay,dmx signal,endcode,temperature
Protection,Temperature,fans seepd,screen protection,screen reverse, factory reset, rest motor,
System info
(running time, total running time, software version, run mode, address, temperature
SIDIUS LED 368 Z User Manual/Manual de uso Page 4
EN
