Mark G(N)CT/RE, Техническое руководство

Страница: 4 / 88

Key to table [3]
T Type
A Nominal power
B Nominal load (lower value)
C Gas consumption with specific gas type
D Burner pressure variation with specific gas type
E Total number of injectors
F Nominal Air Displacement
G Delta T
H Throw G(N) S T/R E
I Noise level at 3m G(N) S T/R E
J Weight G (N) S T/R E
K Electrical power G(N) S T/R E
L Intake/outlet diameter
M Flue fan opening on category specified
N Bypass opening on category specified
O. Restricted shortened roof pass-through on category specified
P. Restricted shortened wall pass-through on category specified
* special Low No
x
appliance
1.3 Warnings
General warnings
Incorrect installation, adjustment, alteration, maintenance activity or repair may lead to material
or environmental damage and/or injuries. The appliance should therefore be installed, adapted or
converted by a skilled and qualified installer, taking into account national and international
regulations. Faulty installation, adjustment, alteration, maintenance activity or repair shall render
the warranty void.
Appliance
When installing wall air heaters, you must comply with the national and, if applicable, regional and
local regulations (e.g. gas company regulations, building regulations etc.). The wall air heater may
be installed only in an area and position suitable for the purpose, see Chapter 2 Installation.
Gas supply and connection
Before installation, check that the local distribution conditions, gas type and pressure and the
current adjustment of the appliance all match. An approved gas stop cock must be fitted to the
inner pipeline.
Flue gas route
Combustion air supply pipelines and combustion gas exhaust ducts should have as few bends as
possible; in general, the resistance should be kept to a minimum and in all cases, the diameter
should be constant along its entire length. The exhaust duct must not rest on the heater, but
should be suspended efficiently! If the flue gas exhaust duct passes along or through combustible
walls or floors, the duct must be sufficiently free to prevent fire.
4