PRIMER ORIENTATION SENSOR INSTRUCTION MANUAL VERSION 1.1
3
Installation Instructions:
The Primer orientation sensor installs into station # 5, the station after the primer seating station. To
install the sensor the Shellplate must be removed or lifted to remove the spacer housing. Although
it’s
not required, we do recommend to remove the tool head for full access. Below are the installation steps
for installing the sensor on a Revolution (shown). Evolution and Apex10 process is the same.
Step 1: Removing Press Top End
1.
Remove Tool Head
2.
Remove Shellplate nut
3.
Loosen the Shellplate retainer clamps and remove the Shellplate spring.
4.
Remove the Shellplate
5.
Remove Spacer Block by loosening 2X 10-32 from the underside of the Priming Assembly with a
9/64” Allen Key
Figure 1: Revolution Press Top End disassembled for Sensor Installation
Revolution Press
Spacer Block
Hardware
–
(Re-Use)