Marine Revolution
Smartwave SW 4200 Owner’s Manual
Page
9
Smartwave Boat trailers are constructed using runners to support the boat and avoid point loading
associated with rollers. Do not leave your boat on blocks or on the trailer unmoved for long periods of
time.
If your boat is kept on the water it is beneficial to periodically slip your boat in order to inspect the hull
and any fittings, equipment, etc.
Do not use the tilt support lever or rely on the hydraulic tilt to support the outboard when trailering
the boat. The outboard can shake loose or the hydraulics may fail causing the motor to fall.
The outboard motor should be trailered and stored in the normal running position. If there is
insufficient road clearance in this position, then trailer the outboard motor in the tilt position using a
motor support device such as a transom saver bar.
Bilge pumping system
(
ISO 15083
)
It is the responsibility of the owner/operator to have at least one bailer/draw bucket on board, secured
against accidental loss
If your craft is fitted with an electrical bilge pump, please note the location of the switch on the helm
switch panel. The manufacturer’s manual will be supplied. Please refer to this manual for specific
operation and maintenance information.
