SYSTEM DIAGRAM
Check the box thoroughly for all parts listed for the type of unit purchased. All units come standard
with a Garden Hose Fitting. If the feed water (faucet or laundry sink) does not have ¾” garden hose
threads, you will need to purchase a Feed Water Adapter, or a Faucet Coupler. These and other sold
separately plumbing parts are available at MarineDepot.com or your local hardware store.
The pressure gauge (Figure A; included with Advanced models) will allow you to monitor the pressure
of the system and make sure that the filter is receiving sufficient water pressure to operate efficiently
as well as monitor your pre-filters. It will indicate, via a drop in pressure, when the sediment and
carbon block filters are clogged and need to be replaced.
The Dual or Triple TDS meter (Figure A; included with Advanced models) is used to monitor the
condition of the TFC membrane and DI cartridge.
Flush Valve kit (Figure A; included with Advanced models) purges the TFC membrane and helps to
extend membrane and DI cartridge life. We recommend flushing your membrane for 30 seconds
before and after each use.
STORAGE
When the unit is not in use, it is important to keep the TFC membrane hydrated. The TFC membrane
must not be allowed to dry out. Keep the unit in a cool location and keep all inlet and outlet lines above
the unit so the water will remain in the unit. If the RO (or RO/DI) system will not be used for more than
4 weeks, remove the TFC membrane and store it in a refrigerator inside a Ziploc bag filled with a small
amount of purified water. Do not allow the RO (or RO/DI) unit to be exposed to freezing conditions or
temperatures above 100°F.
Figure A:
Pressure gauge - TDS
Monitor - Flush Valve
Figure B-3:
KleanWater 4-Stage Advanced
RO/DI System
Figure B-1:
KleanWater Basic RO System
Figure B-4:
Marine Depot KleanWater
6-Stage Economy RO/DI System
Figure B-2:
KleanWater 4-Stage Economy
RO/DI System
Figure B-5
KleanWater 6-Stage Advanced
RO/DI System
3
Visit marinedepot.com/kleanwater
