Although we have taken all the precautions to make
your equipment completely safe and to comply with the
safety standards, we recommend to unplug it from the
wall outlet if your are not going to use it for an extended
period of time.
Keep the equipment in a well-ventilated area and far
away from materials that can be ignited.
Do not expose to rain or direct sunlight.
Do not open. High voltage no serviceable parts inside.
The voltage supply should be ± 15% of the line nominal
voltage specified in the product.
To clean, use a soft lightly humid cloth.
Never take the tubes out while the amplifier is plugged!
It is important to substitute the tubes with the correct
numbers.
Troubleshooting
Doesn’t turn on
Look for:
- Proper connection to the wall outlet.
-The rear switch to be in on position.
-The U280 SC has a
3-minute delay
pre warm up time.
Wait until the current meter display reaches 35ma.
- The circuit breaker in the rear of the amplifier is
probably activated, if you see the button ejected push it
in.
One channel doesn’t sound
Look for:
-The gain controls to be in the correct position.
-The connections to be properly set.
- A protection fuse can be blown, check them and if is
the case replace it.
Warning HIGH VOLTAGE inside.
Be certain to have the amplifier unplugged from the
power line.
If the fuse blows again one tube is in short or damage,
replace it.
The amplifier does not sound properly.
Look for:
-The proper voltages supply.
-The amplifier output impedance selector to be in the
proper position.
-
Check for further advises in the operation section of
this manual.
Noise in your system.
Check for ground loops in the system.
-
No more than one physical ground should have the
system.
Advises
Always mount your amplifier in a firm platform avoiding
external vibrations from loudspeakers.
You can change the tonal characteristics by placing your
amplifier in different type of supports like footer, spikes,
etc.
To minimize unwanted noise in the system:
Avoid excessive length in the interconnect cables.
Avoid having AC line cables and strong electromagnetic
fields near the signal ones.
Because you have a servo-controlled bias and the
BEFS always use the best interconnects, AC power line
and loudspeakers cables that you can get.
We recommend having the gain potentiometers at
maximum level; In our opinion you will achieve the best
sounding qualities.
Содержание U280sc 25th
Страница 5: ...Margules U280sc 25th User manual...
