-10-
Troubleshooting
If the Power Indicator Light does not light:
Check that the unit is plugged into a working power outlet.
If liquid leaks from the base of the Blending Jar:
Remove it from the unit and check that the Blending Blade Sealing Ring is
properly installed and that the Blending Jar Base is tightened.
If water leaks from the unit:
Empty the Ice Melt Reservoir.
If the Blending Jar overfl ows during the Shave ’n Blend
™
cycle:
Follow the drink recipes included in “making frozen drinks” section and make
sure to not exceed the specifi ed total volume.
If the Blending Jar will not sit on the Blending Base:
Remove it from the unit and check for ice on the Blending Base.
WARNING: unplug the unit before removing ice from the Blending Base.
If the unit is in fault mode (fast blinking red status compass rose indicator light):
Check that the Ice Reservoir and Ice Reservoir Lid are properly installed and
in the lock position.
If the drink is too watery:
Make sure to follow the recipe guide (pg.5) or
manually shave more ice until the desired consistency is achieved.
Dos and Don’ts
DO NOT
place fi ngers into the Blending Jar or Ice Hopper. The blades in this
unit are sharp and could cause injury.
DO NOT
place Blending Jar onto Blending Base while motor is running. The
spinning Blending Base could damage the Blending Jar.
DO NOT
twist Blending Jar when removing. Simply lift and remove. Twisting
the Blending Jar could loosen the Blending Jar Base causing it to leak.
DO NOT
put hot liquid into the Blending Jar. Hot liquids could be ejected
during the blending process causing injury.
DO NOT
place ice, frozen foods or very cold liquids into a Blending Jar which
has come directly from a hot dishwasher. The sudden change in temperature
could cause the Blending Jar to crack.
DO NOT
place very hot liquids or foods into a Blending Jar that has come
directly from the freezer. The sudden change in temperature could cause the
Blending Jar to crack.
DO
follow the cleaning and maintenance instructions prior to your fi rst use
and after subsequent uses.
DO
unplug the unit when not in use.
