Revision 1.0
Page 11
Figure 6
– LAN Connection
2.4.2 USB Device Connection
There are two external USB 2.0 connectors. The USB connectors are used to transfer N2KView
®
configurations between the TSM1330C and other N2KView
®
devices, and also for applying software
updates to the TSM1330C. Install the included waterproof USB bulkhead connector in a position
where it is easily accessible and plug into one of the USB connectors on the TSM1330C per the
instructions below. This will make the USB connection easily accessible once the TSM1330C is
installed.
The USB connectors may optionally be used to install USB keyboards or USB mice for an alternative
means of controlling the TSM1330C user interface.
To connect a USB 2.0 or USB 1.1 device, please follow the instructions below.
Step 1:
Locate the USB connectors. The locations of the USB connectors are shown in Figure 4.
Step 2:
Align the connectors.
Align the USB device connector with one of the connectors on the
bottom panel. See Figure 7.
Step 3
: Insert the device connector. Once aligned, gently insert the USB device connector into the
onboard connector.