MAREDO GT 210 05, Руководство пользователя

Страница: 4 / 9

4
TIPS/ REMARKS.
1.Do not use the spiker unit in very wet conditions.
2. Clean the unit regularly with air or low pressure water. DO NOT USE HIGH
PRESSURIZED WATER.
3. If the centre hydraulic motors do hit each other (TORO), you can place the front
units a little offset.
4. Play with the engine throttle and the driving speed, if the holes do not look nice.
Too much vibration in weak turf may cause damages. Reduce engine revs or increase
forward speed.
5. You may use the heads without drive. For that it is the best you remove the
hydraulic motors from the heads.
6. Be careful when dropping the units on a hard (concrete) floor. PUT SOMETHING
UNDERNEATH TO PROTECT THE SPIKES, PLATES OR ROLLERS.
7. Check bolts and nuts regularly.
8. START AND STOP PROCEDURE: Set the engine throttle at appr. 75%. Drop the
units and move forwards. Increase throttle if necessary ( otherwise stay at 75%). At the
end of the pass, reduce engine rpm till 75% and raise the units. NOTE: Because the
spikes start spinning when dropping the heads, they may hurt the turf. Start with lower
rev’s, outside the green or engage the drive of the heads when the spikes are in contact
with the soil (if possible).
9. You can make curves with the units during work, BUT DO NOT MAKE TIGHT
CURVES. Damage to the units and green may appear.
10.
CHECK THE (HYDRAULIC) DRIVE OF THE GREENSMOWER
REGULARLY. DO NOT OVERLOAD THE GREENMOWER. MAREDO IS
NOT RESPONSIBLE FOR DAMAGES TO THE GREENSMOWER
.
11.
As an option, a trolley is available, that can be easily connected to each head. Next
you can easily roll the head in and out the greensmower.
12. You can set the depth by changing the front roller position. Set both side at the
same position.
13. As options, we have more different types of spike tools available, that fit on the
main sections. Either thinner spikes or even continuous disks. The vibration help them
doing the work, like with the standard spikes.