www.marcumtech.com
- 9 -
To install, first remove the loop tape from the hook tape. Peel the adhesive
cover and apply the strips of loop tape to each side and the top of the monitor.
The hook tape attached to the shroud can now be married to the loop tape on
the monitor, and your monitor can now be more easily viewed in sunlight.
If you need to remove the battery, unplug the two battery terminals from the
battery. Remove the hook and loop strap that is holding the battery in place
and lift the battery out. To replace the battery, place a new battery of similar
specifications into the battery compartment and secure it with the hook and
loop strap and re-connect the positive and negative terminals.
If your viewing image appears cloudy, fuzzy or the screen begins to shrink,
check your battery charge. One of the major symptoms of a dead or near-
dead battery is the degradation of your viewing image. Try charging your
battery or if the battery is unable to hold a charge, replace it with a new one of
similar specification. If you need to remove the battery, unplug the two battery
terminals from the battery. Remove thehook and loop strap that is holding the
battery in place and lift the battery out. To replace the battery, place a new
battery into the battery compartment and secure it with the hook and loop
strap and re-connect the positive and negative terminals.
Tip: To preserve battery run time, try to keep the VS385C in a relatively warm
environment to minimize the use of the built in LCD heater system. By starting
out with a warm monitor, there is less power consumed and less warm up time
required.
Product Performance Specifications
Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 volt DC, 7.2 Amp hr
Charger . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 volt DC
Camera Image Sensor . . . . . . . . . . . . . . . . Sony SUPER HAD II CCD
Light Sensitivity . . . . . . . . . . . . . . . . . . . . . .01 lux with lights on
Field of View . . . . . . . . . . . . . . . . . . . . . . . 90 degrees
Monitor . . . . . . . . . . . . . . . . . . . . . . . . . . . 7” (800 x 480)
Current Draw
System ON (lights Off) . . . . . . . . . . . . 630mA
System ON (lights On - full) . . . . . . . . 815mA
