1.
Interior Light
2.
Control Pane
3.
Door
4.
Shelves
(6 Full + 1X Half)
5.
Handle
6.
Door Seal
7.
Leveling Leg
BEFORE USING YOUR APPLIANCE
Remove the exterior and interior packing.
•
Before connecting the appliance to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
•
Clean the interior surface with lukewarm water using a soft cloth.
•
Install the handle on the door.
(See page
5
.)
INSTALLATION OF YOUR APPLIANCE
•
T
HE APPLIANCE IS DESIGNED FOR FREE-STANDING INSTALLATION ONLY
.
•
WARNING
: Do not store or install the appliance outdoors.
•
CAUTION
:
This appliance is designed for storing and cooling beverages and drinks. Do not store
perishable food, medicine or other medical products.
•
Place your Wine Cooler on a floor that is strong enough to support it when it is fully loaded. To
level
the unit, adjust the front leveling legs.
•
For free-standing installation, leave 5 inches (127mm) of space around the back and sides of the
unit to allow proper air circulation to cool the compressor and condenser.
•
NOTE: It is recommended that you do not install the appliance near an oven, radiator or other
heating source. Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Don’t install in a location where the temperature will fall below
60°F (15°C)
.
For best performance, do not install the appliance behind a cabinet door or block the base grille.
Avoid locating the unit in moist areas.
Plug the Wine Cooler into an exclusive, properly grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized service center.
4
MBC145-BL
