5
ENGLISH
FOREWORD
This section must be read before any connection is made to
the mains supply.
WARNINGS
Do not expose the equipment to rain or moisture.
Do not remove the cover from the equipment.
Do not push anything inside the equipment through the
ventilation holes.
Do not handle the mains lead with wet hands.
EQUIPMENT MAINS WORKING SETTING
Your Marantz product has been prepared to comply with the
household power and safety requirements that exist in your
area. Please make sure the mains voltage of your area and the
version of this product (written on the back) are correct.
The voltage of this version is set to 120V AC only.
COPYRIGHT
Recording and playback of any material may require consent.
For further information refer to the following:
— Copyright Act 1956
— Dramatic and Musical Performers Act 1958
— Performers Protection Acts 1963 and 1972
— any subsequent statutory enactments and orders
ABOUT THIS USER GUIDE
The names of controls and indicators on this users guide
correspond to “FIGURES” on page 8. If you want to know more
information, please see “NAME OF CONTROLS AND
INDICATORS” on page 9.
PRECAUTIONS
The following precautions should be taken when operating the
equipment.
GENERAL PRECAUTIONS
When setting the equipment ensure that:
— the ventilation holes are not covered
— air is allowed to circulate freely around the equipment
— it is on a vibration free-surface
— it will not be exposed to interference from an external source
— it will not be exposed to excessive heat, cold, moisture or
dust
— it will not be exposed to direct sunlight
— it will not be exposed to electrostatic discharges
CONNECTIONS
CONNECTION OF SPEAKER SYSTEMS
The SM6100A has two pair of speaker terminals on the rear
panel (SYSTEM A and B).
- When a pair of speaker system are connected to either
SYSTEM A or B speaker terminals, the speakers with
impedance of less than 4ohms are connected, the protection
circit may be activated.
- When two pair of speaker systems are simultaneously
connected to the SYSTEM A and B speaker terminals, the
impedance of each speaker systems should be no less than
8ohms. Connecting a speaker system with lower impedance
than 8ohms may activated the protection circitry and make
normal operation impossible.
Turn counter-
clockwise to
loosen.
Strip coating from extermity.
Twist conductors.
Speaker cord
Turn clockwise to
tighten.
Insert conduc-
tors.
Connection of speaker cord
Содержание SM6100SA
Страница 1: ...Model SM6100SA User Guide Power Amplifier...
Страница 2: ......
